How to Fix Windows Couldn’t Load Correctly Error

Boot Windows into Safe Mode and uninstall latest installed device driver or software within Safe Mode.

If you cannot boot Windows into Safe Mode, boot your computer with Windows Installation DVD and from Windows Recovery Environment start the Command Prompt.

Type below command into Command Prompt and press Enter key.

Following command will  fixes errors on the disk and locates bad sectors and recovers readable information.



Replace partition letter D: with Windows installed partition letter.  When computer boots into Windows Recovery Environment (WinRE) environment the drive letter assign to Windows partition may not be C: drive letter because Windows 7, 8 , 8.1 and 10 creates a separate system partition when it's installed from scratch. The system partition contains boot files WinRE assigns the system partition the C: drive letter and the Windows installed partition will be assign any other drive letter usually D: drive letter is assign to Windows installed partition. The Bcdedit /enum | find "osdevice" command can be use to find out the drive letter of the Windows installed partition the output of the Bcdedit command is similar to this osdevice partition=D:. The drive letter after partition= is the drive letter of the Windows partition.


While a misconfigured BCD data store might not be the cause for this error, it’s worth rebuilding the Windows’s BCD and checking again:

Boot your computer with Windows Installation DVD and from Windows Recovery Environment start the Command Prompt.

Type below commands into Command Prompt and press Enter key.

Following commands will repair Master Boot Record (MBR), Boot Sector and BCD Store.



Reboot your computer and hopefully Windows will boot normally now.